The new version ATHENA 2008 has appeared now. ATHENA 2008 runs under AutoCAD/ADT 2007
and AutoCAD/Architecture 2008
Here is a selection of the new features (no responsibility accepted for correctness):
-
Many new standard parts (e.g. welded studs, SPAX screws, SFS screws, new sheet screws, new
metric screws, etc.).
-
New MFC dialog boxes (some known commands in ATHENA now have MFC dialog boxes which are
more versatile and faster than AutoCAD DCL boxes).
- 3D functionality extended.
- New interface to LogiKal.
-
Sheet processing: Has been extended by some functions (e.g. development of composite sheets).
- Autom. labeling now possible parallel in two languages.
- ATHENA operation: Formatting now possible.
- Material configuration now much easier.
-
New routine Array Division: Distribution of rectangular geometries in a freely
selectable area with evaluation (e.g. panels or sheet).
- Etc.
27.09.2007
